For this week, after we had finish with the coding we solder the circuit for the proximity sensor circuit and trouble shooting the circuit. This is the connection of the proximity part.
Connections:
HC-SR04 Sensor
- The HC-SR04 Ultrasonic Module has 4 pins,
Ground, VCC, Trig and Echo. The Ground and the VCC pins of the module needs to
be connected to the Ground and the 5 volts pins on the Arduino Board
respectively and the trig and echo pins to any Digital I/O pin on the Arduino
Board.
- The HC-SR04 sensor attach to the Breadboard
- The Sensor VCC connect to the Arduino Board
+5V
- The Sensor GND connect to the Arduino Board
GND
- The Sensor Trig connect to the Arduino Board
Digital I/O 9
- The Sensor Echo connect to the Arduino Board
Digital I/O 10
Buzzer and LED
- The Buzzer attach to the Breadboard
- The Buzzer long leg (+) connect to the Arduino
Board Digital 11
- The Buzzer short leg (-) connect to the
Arduino Board GND
- The LED attach to the Breadboard
- The Resistor connect to the LED long leg (+)
- The Resistor other leg (from LED's long leg)
connect to the Arduino Board Digital 13
- The LED short leg (-) connect to the Arduino
Board GND
Subscribe to:
Post Comments (Atom)
WEEK 15 (13.11.2017 – 17.11.2017)
For this week, we had done our project and just need a little touch up before the exhibition which is on 15 th November 2017. Besides, we ...
-
For this week, we had go to Jalan Pasar, Pudu to buy the thing needed for our ‘anti-lost’ circuit. The thing needed in our circuit are: ... -
For this week, we had a problem regarding the motors, one of them had been broke because of the over electric flow. We had put the curren... -
For this week, we had been asked to submit the draft for chapter 1, 2 and 3 of the report to our supervisor. Since we got the problem with ...
Emperor Casino | Shootercasino
ReplyDeleteAs 제왕카지노 one 인카지노 of the fastest growing online casino brand, the EmperorCasino has been around since 온카지노 the moment it first opened in 2009. Its gaming content is extensive